•To test the impedance of the entire speaker system, first disconnect the speaker wires from the amplifier and then measure the impedance from the disconnected wires, as shown below.
Amplifier
Red Wire (+) disconnected from Amplifier
Test Points
Black Wire | To next speaker |
from Amplifier |
|
_ _
Captive Screw
Connector
Impedance Test Points
ATTENTION: Disconnect the speaker system from the amplifier before performing this test, otherwise you may damage the test meter.
•The impedance of the speaker downstream of the one being tested can be measured while the system is powered on by first disconnecting the captive screw connector from the speaker being tested and then connecting the test probes to the outer (LOOP) terminals of the connector, as shown below.
ATTENTION: Be certain to first disconnect the captive screw connector from the speaker being tested and test the outer (LOOP) terminals, otherwise you may damage the test meter.
Amplifier
Red Wire (+) from Amplifier
Black Wire | To next speaker |
|
Test Points
_ _
Captive Screw
Connector
Impedance Test Points
SF 26X User Guide • Installation | 6 |