•Wiring Multiple Speakers Using Loop-through:
A
SF 26X. Connect the wires to the captive screw connectors of the speakers, as shown below. Be sure to tighten the screws.
NOTES:
• Be sure that the combined impedance of the speaker system does not equal a value less than the rated minimum load impedance of the amplifier.
• When a chain of speakers is wired in this configuration, disconnecting one speaker removes power from the remaining speaker in the chain.
| (Red) |
| (Black) |
Power Amplier | _ |
| _ |
(Red)
(Black)
_ _
Speaker 1 | Speaker 2 |
This configuration is useful for troubleshooting in four ways:
•The system is sectioned for easier troubleshooting.
•The source signal can be tested by connecting to the inner + (IN) and inner
– (IN) terminals of the captive screw connector, as shown below.
Red Wire (+) from Amplifier
Amplifier
Black Wire
Test Points
_ _
Captive Screw
Connector
Signal Test Points
SF 26X User Guide • Installation | 5 |