XTP T UWP 302 • Installation and Operation 15
Operation
After all transmitters, all receivers, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, verify that the cables are routed and
connected properly. If problems persist, call the Extron S3 Sales & Technical Support
Hotline. See the contact numbers on the last page of this guide for the nearest Extron office.

Indicators

AUDIO IN
PWRHDCPHDMIVGA
HDMI IN
VGA IN
a
Figure 16. XTP T UWP 302 Indicators
a Indicators
Power LED indicator — Lights when power is applied to the unit.
HDCP LED indicator — Lights when the input signal is encrypted.
HDMI LED indicator — Lights when the active input video signal is HDMI.
VGA LED indicator — Lights when the active input video signal is VGA.

EDID

To manage EDID on the XTP T UWP 302, use the XTP System Configuration Software (see
XTP System Configuration Software on page 22). The XTP T UWP 302 can record and
save EDID in a user memory location, select a pre-defined EDID, or use EDID from a display
connected to a receiver. EDID stored in the user memory location can come from the display
connected to a receiver or a custom EDID imported through the XTP System Configuration
Software.
NOTE: In matrix applications, EDID on the transmitter is assigned by the matrix
switcher using the XTP System Configuration Software.