XTP T UWP 302 • XTP System Configuration Software 31
General tab
Click the General tab to open the general screen. It contains settings for executive mode,
auto switch mode, and factory reset.
Figure 30. General Tab
Executive mode section
Unlock the front panel — Click the Unlock Front Panel radio button (default) to disable
executive mode.
Lock the front panel — Click the Lock Front Panel radio button to enable executive
mode.
Auto-input Switching section
Auto-input switching — Click the Enable Auto-Input Switching check box to enable
auto switch mode. Two settings are available for this mode.
Click the Priority to highest active input number radio button to automatically
switch to the highest numbered active input.
Click the Priority to lowest active input number radio button to automatically
switch to the lowest numbered active input.
Factory reset
Click the Factory Reset button to reset the transmitter to factory settings except for
firmware.
NOTE: This is the same as the EZXXX SIS command (see the System reset
command on page 21).