XTP T UWP 302 • Introduction 1
Introduction
This section contains general information about this guide and the Extron XTP T UWP 302
wallplate transmitter. Topics in this section include:
• About this Guide
• About the XTP T UWP 302
• Key Features

About this Guide

This guide contains installation, operation, and control procedures, and reference information
for the XTP T UWP 302 wallplate transmitter. In this guide, the terms “XTP T UWP 302” and
“transmitter” are used interchangeably to refer to the XTP T UWP 302 transmitter.

About the XTP T UWP 302

The Extron XTP T UWP 302 is a two-input transmitter that sends HDMI or RGBHV video,
audio, and bidirectional RS-232 and IR up to 330 feet (100 meters) over a single CAT 5e,
6, or 7 cable (CATx). This three-gang wallplate transmitter supports computer-video to
1920x1200, including HDTV 1080p/60 Deep Color and 2K. The XTP T UWP 302 works
with XTP Systems for signal distribution and long-distance transmission between remote
endpoints.
The XTP T UWP 302 can be powered locally or remotely through an Extron Power Injector or
XTP matrix switcher (see Power Connection on page 13).
To configure and control the XTP T UWP 302, connect a host device, such as a computer,
and enter Simple Instruction Set (SIS) commands (see SIS Configuration and Control on
page 17) or use the XTP System Configuration Software (see XTP System Configuration
Software on page 22).
Extron
XTP T UWP 302
Universal XTP Transmitter
POWER
12V
HDMI
--A MAX
RxGTx
RS-232 IR R
L
Rx
Tx -
+-
+
12
AUDIO
OFF
ON
AUDIO
S/PDIF
RESET
LAN
SIG LINK
XTP IN
OVER XTP
OUTPUTSRELAYS
ACT LINK
SIG LINK
XTP IN
Extron
XTP R HDMI
XTP Receiver
CAT 5-Type
Cable
Laptops
Display
HDMI
HDMI
VGA
Audio
AUDIO IN
PWRHDCPHDMIVGA
HDMI IN
VGA IN
Figure 1. Typical Point-to-Point Application Diagram