!WARNING
DUE TO THE SIZE AND WEIGHT OF THIS RANGE- HOOD, THREE PEOPLE ARE REQUIRED TO INSTALL THE CANOPY. Two people must hold the canopy in place while the third person installs the screws that attach the canopy to the chimney. The manufacturer assumes no responsibility for injury or damage caused by improper installations.
4.From below, attach the CANOPY SECTION (A in FIGURE 10) to the assembled chimney support using the four screws provided (F in FIGURE 10).
FIGURE 10
MAKE THE INTERNAL ELECTRICAL CONNECTIONS
5.Remove the metal brackets located on the top and bottom of theundersideoftherangehoodbyremovingthescrews(FIGURE 11). Removing these brackets provides access to the control and lighting cables which must connect to the control and lighting cables from the inside of the chimney (FIGURE 12).
H
FIGURE 11
6.Run the control cable (A in FIGURE 12) from inside the chimney through the hole (H in FIGURE 11) in the appropriate bracket. Be sure to place the black rubber grommet around the cable inside the hole to protect the cable from being nicked by the metal hole. Connect the control cables together as indicated in FIGURE 12. Tuck them away under the brackets and reinstall the brackets. Repeat this process for the lighting cables (B in FIGURE 12).
A
FIGURE 12
B
For ductless installations, install the CHARCOAL FILTER (G in FIGURE 8) behind the center grease filter opening by inserting and locking into place.
FIGURE 13
7.Install the grease filters using two hands by first pulling and turning the knob to the left so that the locking lever does not protrude from the filter (as in FIGURE 14). Insert the opposite end of the filter into the retaining channel. Insert the knob end next, then turn knob to the right to lock the filter into place.
FIGURE 14
8.Turn the power supply on. Turn on blower and lights. If the rangehood does not operate, check that the circuit breaker is not tripped or the house fuse blown. If the unit still does not operate, disconnect the power supply and check that the wiring connections have been made properly.
Version 3/08 - Page 8
