
2 WATER AND DRAINAGE CONNNECTION
installation and assembly
WATER
CONNECTION
The water supply hose is inside the drum:
a Connect the bent end of the hose to the threaded inlet located on the back of the washing machine.
b Connect the other end of the hose to the water intake. Then securely tighten the connection nut.
It is important that the drain hose is correctly fastened to the outlet, to prevent any risk of it becoming detached and causing flooding.
| If your washing machine has a hot |
|
| water intake, connect the hose with |
|
Important | the red threaded end to the hot water |
|
tap, and to the electrovalve with the |
| |
|
| |
| red filter. |
|
| The machine must be connected to |
|
| the mains water supply, using the |
|
| new hoses supplied with the |
|
| appliance. Do not use water supply |
|
| hoses that have been used before. |
|
| For your washing machine to work |
|
| properly, the water |
|
| between 0.05 and 1MPa (0.05 and 10 |
|
| Kgr/cm2). |
|
| DRAINAGE | a |
| CONNECTION |
|
a It is recommended that you have a fixed | 28’’ | |
| drainage outlet | |
|
| |
| floor. |
|
| Make sure there are no kinks or bends | 20’’ |
| in the hose. | |
|
| |
|
| 7 |