Falcon SUP1.0K-1C, SUP700-1C manual Battery Charging, UPS Reset, Remote Control

6.Battery Charging

This UPS is shipped from the factory with its batteries fully charged. However, some charge may be lost due to the self discharge characteristics of the internal sealed lead-acid battery. Always allow the UPS to recharge for 24 hours prior to use. To recharge, simply connect the UPS line cord to a powered receptacle. The UPS does not have to be turned on for batteries to recharge. During normal use, the UPS will self recharge should the battery be depleted due to a loss of utility power.

7UPS Reset

In the event the UPS will not accept commands and appears to be locked up, depress the control button for and hold for ten seconds. The UPS CPU will be reset.

8.Remote Control

The UPS can be set for an automatic daily shutdown and start up. This command must be set through the RS-232 interface using the supplied software. When this function is set, a timer inside the UPS will begin to run.

The load will be turned off according to the shutdown and start up schedule set in the software, which is then transferred and stored in the UPS memory. During the period of turn off to the next turn on, the status LCD "time entered" symbol will blink.

12