Troubleshooting

Caution

CAUTION

 

Symptom

 

Items to Check

 

 

 

 

 

Buttons do not work.

 

Is the power turned on?

 

 

 

 

 

No sound

 

Is the audio which is connected with

 

 

 

the audio cable set to receive

 

 

 

the DVD signal output?

 

 

 

Is audio cable connected securely?

 

 

 

Is the monitor which is connected

 

 

 

with the audio cable turned on?

 

 

 

Is the audio output set

 

 

 

in the correct position?

 

 

 

 

 

Remote control does

 

Is the remote control facing

 

not work properly.

 

the remote sensor?

 

 

 

Is the distance too far?

 

 

 

Is there any obstacle in the middle?

 

 

 

Is the battery weak?

 

 

 

 

 

 

 

 

Actions to be Taken

Check the car battery capacity.

Select the correct input mode for the audio receiver. Connect the audio cable into the jacks securely. Turn on the monitor connected with the audio cable.

Set the Audio Output to the correct position,

and then turn on the DVD player again by pressing the POWER button.

Point the remote control toward the remote sensor of the product.

Use the remote control within 15 feet.

Remove the obstacle.

Replace with new battery.

Quality installations are best performed by qualified and certified installers.

Don t touch the unit if there is a flash of lightning. You may receive an electric shock.

Do not cover or stop up heater ducts or vents. It may cause a fire or receive an electric shock.

Watching the monitor for an extended period of time without the engine running may deplete the vehicles battery charge.

This product is designed for operation with a 12 Volt DC, negative ground vehicle. It is not suitable for operation under other conditions or voltages.

Do not bring magnetic devices such as credit card or magnetic card near the magnets.

Moisture or condensation on lens

When a disc is brought from a cold environment to a warm one, there may be moisture on the the disc, or condensation on the pickup lens. It will affect disc playback.

1.Remove the disc from the DVD player.

2.Turn on the power and leave it on for an hour to vaporize the condensation.

36

Operating Notes

1.The operating temperature of this product is limited to 14 ~+140 F.

2.If your vehicle is extremely hot or cold you must allow time for your air conditioner or heater to cool or heat the vehicle until operating temperatures have returned to normal operating ranges.

3.Optimal picture quality is achieved when viewed from directly front of the monitor (+/-30degrees).

4.Do not open the housing and attempt to make any repairs yourself. Refer servicing to qualified personnel.

5.DVD Players use an invisible laser beam which can cause hazardous radiation exposure. Be sure to operate the unit correctly as instructed.

6.Do not cut the car power supply off while a disc is playing. It can cause damage to the DVD Player.

7.If the buttons get stuck, please try to press the up of buttons, it will get back. It won't impact using normal.

8.If you cann't find the files name in list when playing, please reset units or turn off/on over again.

9.If the unit cann't be change mode when playing some special files which the unit didn't support, please reset units or turn off/on over again.

5

Page 5
Image 5
Farenheit Technologies MD-900CM owner manual Troubleshooting, Operating Notes