Chassis Installation
1.Remove front closure panel. Remove
2.Remove the rear louver panel and rear closure panel through the inside of the sleeve by removing the screws. Reinstall rear louver panel in the sleeve (Fig. 2).
3.If time has elapsed since the sleeve was installed, recheck level for 1/2 bubble outward pitch.
4.Slide chassis into sleeve as far as possible.
5.Attach decorative front (sold separately). DO NOT OPERATE THE AIR CONDITIONER WITHOUT THE DECORATIVE FRONT.
If you are installing this unit into an existing Fedders sleeve, please com- pare the depth of your existing sleeve and the depth of your new unit. If you are installing the “A” size unit into the deeper “B” sleeve, adapter kit AXB005AB (sold separately) must be used. If you are installing the “B” size unit into the shallower “A” sleeve, adapter kit AXA00A2B (sold separately) must be used. These kits are designed to provide maximum efficiency and proper installation of the unit without having to remove and replace your existing Fedders sleeve.
WARNING
These panels cannot be removed from outside of structure.
Use caution when working around exposed sharp edges of the cabinet and sharp coils to avoid injury or torn clothing.
Proper use and care of your air conditioner will help ensure longer life of the unit. It is recommended to
annually inspect and clean the coils and condensate water passages. Expense of annual inspection is the consumers’ responsibilities.
Troubleshooting
To save time and expense, check the following before calling an authorized service station.
Insufficient Cooling
pTurn Master Control to OFF.
pShut all windows and doors in room.
pRemove any obstructions from inside and outside cabinet louvers.
pInspect filter and clean if dirty.
pTurn Temperature Control to COOLER.
pTurn Master Control to HIGH COOL.
Under certain conditions the cooling coils directly behind the filter, may ice up and block the airflow. This is a common occurrence in air condi- tioners caused when the outside temperature drops below 70°F (21°C) while the humidity remains high. If this happens, simply turn the unit off and allow the ice to melt, then resume normal operation.
Unit Fails to Start
pTurn Master Control to OFF.
pReplug line cord plug into outlet to be sure electrical contact is being made. (If firm contact is not being made, outlet may have to be replaced).
pTurn Master Control to HIGH FAN. If air circulating fan does not operate, check house circuit breaker (or fuses).
Installation/Troubleshooting
1
Support screw
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 |
|
|
| Rear louver panel | Rear closure panel | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ScrewsSleeve
WARNING
This unit should only be installed by a qualified
HVAC technician in accordance with the National
Electrical Code and local codes and ordinances.
Failure to follow these precautions could result in electrical shock, fire, death or serious personal injury.
2
