Federal Security Camera 302GC, 300GCX manual Installation And Service Instructions For, I.General

INSTALLATION AND SERVICE INSTRUCTIONS FOR

MODELS 300GC, 300GCX, 302GC, AND 302GCX

SAFETY MESSAGE TO INSTALLERS

People’s lives depend on your safe installation of our products. It is important to read, understand and follow all instructions shipped with these products. Listed below are some other important safety instructions and precautions you should follow:

•This unit must be installed by a qualified electrician in accordance with all National and Local Electrical Codes, and be acceptable to the Local Authority Having Jurisdiction.

•Do not connect this unit to the system wiring when circuits are ener‑ gized.

•For optimum sound distribution do not install this device where objects would block any portion of the front of the speaker.

•All effective warning speakers produce loud sounds, which in certain circumstances, may cause permanent hearing loss. Take appropriate precautions such as wearing hearing protection. Recommendations in OSHA‑Sound Level Standard (29 CFR 1910) should not be exceeded.

•After installation and completion of initial system test, provide a copy of this instruction sheet to all personnel responsible for operation, periodic testing, and maintenance of the equipment.

Failure to follow all safety precautions and instructions may result in prop‑ erty damage, serious injury, or death to you or others.

I.GENERAL.

These four SelecTone® Models are high output, continuous duty, indoor/outdoor rated audible signal/amplified speaker devices with internal gain controls. A plug-in tone module is required for tone generation. If the use of externally generated tones or voice signals from a remote amplifier is desired, the plug-in speaker connector cards may be used. See the specification section for compatible plug-in models. These models may also be used for playback of pre-recorded messages or tones when used with the Model TM-33 Custom Tone Module. The mounting bracket is adjustable to allow posi‑ tioning to obtain desired sound coverage. Speaker projectors on all models are adjust‑ able and may be repositioned to obtain desired sound distribution.

The SelecTone Models 300GCX and 302GCX are designed for use in areas where Flammable Gases, Vapors and Liquids and Combustible Dusts are not normally pres‑ ent, except for abnormal conditions as defined by the National Electrical Code. These models are suitable for use in Class I, Division 2, Groups A, B, C, & D; Class II, Division 2, Groups F and G; Class III or non-hazardous locations only. Reference the product nameplate for additional information.

-1-