Empire Comfort Systems PV-28SV55-(C,G)2H(N,P)-1 Optional Controllers, Temperature Controllers

	OPTIONAL CONTROLLERS
	TEMPERATURE CONTROLLERS
FRBTP	Battery Operated Remote w/ Programmable Thermostat
FRBTC	Battery Operated Remote w/ Thermostat
TRW	Battery Operated Wireless Remote Wall Thermostat
TMV2	Thermostat, 2 Stage
T24V	Thermostat, 24 Volt

See your Mantis dealer for correct controller type.

INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION Installation Instructions for FRBTP, FRBTC, and TRW

Remote Controls FRBTP, FRBTC and TRW are all battery operated devices. Begin installation by unplugging the unit and removing the front louver panel.

Remove wire nut from black and white wire from junction box.

Black or white wire can be inserted in either remote control receiver connection hole or connected to T24V thermostat screws. There is no polarity at this connection.

REMOTE

CONTROL

RECEIVER OR

T24V THERMOSTAT

BLACK

WHITE

WHITE

JUNCTION	C W2 W1 R
BLOCK
								TO
					BLUE		TRANSFORMER
				RED		TO “T1” (FRONT BURNER)
			BLACK				TO “T2” (REAR BURNER)
		WHITE						TO “T1”
		BLUE						TO “T2”

Figure 49

Replace front louver panel and plug unit into outlet. Turn both burner switches to the ON position. Burner switches must remain in the ON position for remote to function. Set remote from the instructions provided with the remote control. Set T24V thermostat to desired temperature.

Note: When the heater will not be used for long periods, the burner switches should be in the OFF position, and the heater should be turned off at the power point.

Installation Instruction for TMV2 - Two Stage Thermostat Model:

Begin installation by unplugging the unit and removing the front louver panel.

Determine mounting location of thermostat. Using standard 18 AWG wire, run four (4) strands of wire into rear of Mantis (See Figure 50) to junction block. Cut wire to correct length. Remove blue jumper wire from junction block and save for future use. Connect four (4) new thermostat wires to Mantis using schematic. See Figure 51.

Page 42 Figure 50 24820-1-0409