Ferris Industries 5900646, 5900645, 5900636 Mowing Recommendations, Operation, Height of Grass

Models: 5900633 5900647 5900972 5900644 5900637 5900635 5900638 5900646 5900636 5900645

1 48
Download 48 pages 12.01 Kb
Page 22
Image 22
MOWING

Operation

MOWING

Before mowing, set the cutting height as described in the Troubleshooting, Adjustments & Repair section.

1.Engage the parking brake. Make sure the PTO switch is disengaged and the motion control lever is in the NEUTRAL position.

2.Start the engine (see STARTING THE ENGINE).

3.Set the throttle to FULL.

4.Engage the PTO by pulling up on the PTO switch.

5.Begin mowing.

6.When finished, shut off the PTO.

7.Stop the engine (see

STOPPING THE TRACTOR AND ENGINE).

MOWING RECOMMENDATIONS

Several factors can affect how well your machine cuts grass, Following proper mowing recommendations can improve the performance and life of your machine.

Height of Grass

Often cutting height is a matter of personal preference. Typically, you should mow the grass when it is is between three and five inches high. The proper cutting height range for a specific lawn will depend upon several factors, including the type of grass, the amount of rainfall, the prevailing temperature, and the lawn’s overall condition.

Cutting the grass too short causes weak, thin grass plants, which are easily damaged by dry periods and pests. Cutting too short is often more damaging than allowing the grass to be slightly higher.

Letting grass grow a bit longer—especially when it is hot and dry—reduces heat build-up, preserves needed moisture and protects the grass from heat damage and other problems. However, allowing grass to grow too high can cause thin turf and additional problems.

Cutting off too much at one time shocks the plant’s growth system and weakens the grass plants. A good rule of thumb is the 1/3 rule: to cut no more than one third of the grass height, and never more than 1 inch at a time.

The amount of grass you are able to cut in one pass is also effected by the type of mowing system you are using (for example, broadcasting with side discharge decks can process a much larger volume of grass than mulching does).

Tall Grass Requires Incremental Cutting

For extremely tall grass, set the cutting height at maximum for the first pass, and then reset it to the desired height and mow a second or third time.

Don’t cover the grass surface with a heavy layer of clippings. Consider using a grass collection system and starting a compost pile.

Cut Here On

 

 

 

Cut

First Pass

 

 

Here On

 

 

 

 

Second

 

 

 

Pass

 

 

 

20

www.ferrisindustries.com

Page 22
Image 22
Ferris Industries 5900646 Mowing Recommendations, Operation, Height of Grass, Tall Grass Requires Incremental Cutting