8

Technical data

Power consumption

720 W

Rotational speed (no load)

10000 - 26000 rpm

Tool holder

8 mm (0.31")

optional:

6 mm (0.24")

 

1/4"(6.35 mm)

Max. routing tool diameter

26 mm (1")

Weight

1.9 kg (4.2 lbs)

Safety

/II

Symbols

V Volts

A Amperes

Hz Hertz

~Alternating current

n0

No load speed

 

Class II Construction

rpm

Revolutions or reciprocation per

 

minute

ØDiameter

Warning of general danger

Read the Operating Instructions/ Notes!

fAdvice or tip

Scope of delivery

The pictures for the scope of delivery are on a fold-out page at the beginning of the instruc- tion manual. When reading of the manual you can fold out this page for having always an overview of the machine.

[1-1] MFK 700 with large surface router ta- ble

[1-2] Side stop with guide rods and fine ad- juster

[1-3] Extraction hood for large surface router table with extractor connector

[1-4] Router table for edge veneer with feeler roller and extraction hood (only in SET scope of delivery)

Intended use

The MFK 700 EQ is designed for routing wood, plastic and similar materials.

The user shall be responsible and liable for damages and accidents resulting from misuse or abuse of this tool.

Electrical connection

The network voltage must conform to the voltage indicated on the rating plate. A 16 A safety fuse (for 120 V) or a corresponding protective circuit-breaker is required.

See the following figure [2] for connection and disconnection of the power cable.

Always switch the machine off before connecting or disconnecting the power cable!

2

Extension cable

If an extension cable is required, it must have a sufficient cross-section so as to prevent an excessive drop in voltage or overheating. An excessive drop in voltage reduces the output and can lead to failure of the motor. The table below shows you the correct cable diameter as a function of the cable length for the MFK 700. Use only U.L. and CSA listed extension cables. Never use two extension cables together. In- stead, use one long one.

Total Extension Cord

25

50

100

150

Lenght (feed)

 

 

 

 

Cord size (AWG)

18

16

16

14

Note:

fThe lower the AWG number, the stronger the cable.

Page 8
Image 8
Festool MFK 700 instruction manual Technical data, Symbols, Scope of delivery, Intended use, Electrical connection