
Accessories
Sawblades
Description | Coarse Crosscut | Ripping (Panther) | Combination | |
| With a low tooth count and a high | The high hook angle of the | With a moderate tooth count and | |
Purpose | hook angle, this blade provides good | |||
hook angle, this blade easily cuts | Panther blade makes for effortless | |||
results when a single blade is needed | ||||
| through general construction materials. | ripping without burning the cut. | ||
| for crosscutting and ripping. | |||
|
|
| ||
Tooth Type | ATB, 12 teeth | ATB, 14 teeth | ATB, 28 teeth | |
Hook Angle | 20° | 37° | 15° | |
Item Number | 487 377 | 439 685 | 490 516 |
Description | Fine Crosscut | Fine Laminate | Aluminum and Plastic | |
| With a high tooth count, this blade | The | The negative hook angle and high | |
Purpose | provides excellent, | blade provide | TCG tooth count of this blade | |
crosscutting of lumber and fine | laminates and solid surface | provides | ||
| ||||
| materials without dulling. | aluminum and hard plastic. | ||
Tooth Type | ATB, 48 teeth | TCG, 48 teeth | TCG, 56 teeth | |
Hook Angle | 12° | 4° | ||
Item Number | 491 952 | 489 457 | 439 686 |
Notes |
|
| ATB: Alternate Top Bevel. The ATB type blade slices through wood fibers, |
| first on one side and then on the other for clean cuts in natural and |
| manmade materials. |
| TCG: Triple Chip Grind. The TCG type blade is designed to cut through hard |
| materials. The trapezoidal tooth cuts the center of the kerf and the flat |
| raker tooth cuts the edges. This type of blade design is more resistant to |
| dulling. |
| |
| angle of 15°. This moderate bevel angle provides good |
| without rapidly dulling. |
| |
| material and pulls it into the cut. Ripping blades have a very high hook |
| angle to cut aggressively. Lower hook angles are used for harder |
| materials where greater control is needed. |
| Tooth Count: The more teeth a blade has, the smoother it will cut. Conversely, |
| blades with fewer teeth cut more aggressively. |
Instruction Manual | 21 |