FireplaceXtrordinair 36 DV EFIII owner manual Maintenance Instructions

Optional Equipment (for qualified installers only) 5 1

•Run the free wire from the rheostat junction box to the fireplace. Follow the directions below to connect the heat duct circuit to the fireplace.

a	Remove the cover from the
	fireplace junction box.

Note: you may need to loosen this cable clamp to ease removal of the cover plate.

Insert the sheathed cable from the rheostat through a c cable clamp and push the cable clamp into the knock-out

hole to secure it in place. Once the wires are attached, tighten the clamp to secure the cable.

b

Nutdriver	Power
1/4"
	Source
	for
	Fireplace

Electrical Connector (included with the heat duct kit)

Standard

Screwdriver e

Replace the cover removed in step "a".

To optional second power heat vent (use the center knock-out).

Standard

Screwdriver Pry out and discard this knock-out.

Attach the common (white), ground (exposed or green) wires, and hot d (black) wires from the cable leading to the rheostat to the molex

connector. Then attach the molex connector to the fireplace.

MAINTENANCE INSTRUCTIONS

Once a year the grate should be removed and the blower area cleaned. Use a vacuum to clean around the squirrel-cage blower, being careful not to damage any of the blades

Phillips Screwdriver

Use a vacuum cleaner to remove any debris from the power vent blower.

Grill

Travis Industries 4040708 1 0 0 - 0 1 1 6 0