First Alert FA130CP manual $ERXW6FKHGXOLQJ, UHDWLQJ6FKHGXOHV

6FKHGXOLQJ

$ERXW￿6FKHGXOLQJ

The system provides one end-user schedule (programmable by master/installer only), which can control various types of events.

• Each schedule causes a defined event to start and stop (when appropriate) at a specified time.

• Schedules can be set to automatically repeat at various intervals.

• Schedules can be set for random starting, if desired.

&UHDWLQJ￿6FKHGXOHV

1.	+ [#] + [6] [4]	Alpha￿6)%(=-Displays:7%61)(83%61
(Master Code)			)28)67',)(23￿
2. Enter “01” as the 2-digit schedule number.
Press [∗] to continue.			￿￿
3. Enter the desired 2-digit event number from the			)28)6=59-):)28 ￿￿
following list.
00	= clear the scheduled event
01	= turn a programmed output on or off
	(see Using Device Commands section for a list of output device numbers used
	in your system)
02	= set a user access schedule for one or more users
	(see Security Codes section for an explanation of access groups)
03	= send a “latch-key” report to a pager if the system is not disarmed by a specified
	time; message sent is “777-7777.”
04	= automatically arm the system in STAY mode at a specified time
05	= automatically arm the system in AWAY mode at a specified time
06	= automatically disarm the system at a specified time		():-')291&)6<<
07	= Display the word “REMINDER” at a specified time
	Press [∗] to continue.

4.For event number “01,” enter the output number associated with this schedule.

Otherwise, this prompt is skipped.

Press [∗] to continue to the “Start” prompt below.

– 32 –