$UPLQJWKH6\VWHP
$UPLQJ&RPPDQGV
Before arming, close all perimeter doors and windows and make sure the Ready to Arm message is displayed.
Modes of Arming
Mode | Press these keys… | Keypad Confirms By… |
Stay | security code + [3] (STAY) | • three beeps |
|
| • armed STAY message displayed |
|
| • red ARMED indicator lights |
|
|
|
security code + [3] + [3] | • three beeps | |
|
| • |
|
| • red ARMED indicator lights |
Instant | security code + [7] (INSTANT) | • three beeps |
|
| • armed STAY message displayed |
|
| • red ARMED indicator lights |
|
| • also note that entry delay is turned off. |
Away | security code + [2] (AWAY) | • two beeps, or, if programmed, beeping for |
|
| duration of exit delay |
|
| • armed AWAY message displayed |
|
| • red ARMED indicator lights |
|
| Leave the premises through an entry/exit |
|
| door during the exit delay period to avoid |
|
| causing an alarm. The keypad beeps rapidly |
|
| during the last 5 seconds of the exit delay to |
|
| warn you that it is ending. |
Maximum | security code + [4] (MAXIMUM) | • same as Away (described above) |
|
| Note that entry delay is turned off. |
Quick Arming
If "Quick Arming" was programmed by the installer, the [#] key can be pressed in place of the security code when arming the system in any of its arming modes. However, the security code must always be used to disarm the system.
Function Key Arming
For any arming command, a function key may have also been programmed for your system. If so, you can press and hold the appropriate function key for 2 seconds to arm the system. See your installer for the designated functions (see Single Button Arming section).
– 16 –
