First Alert FA148CPSIA, FA168CPSSIA manual Rcvr Jam, Or Check, Alarm, Fault

Trouble Conditions (Continued)

Other Trouble

Displays

*Any “beeping” that accompanies a trouble display can be stopped by depressing any key on the keypad or by entering an OFF sequence (code + OFF)

**Not all systems use wireless sensors.

Words or letters in parentheses ( ) are those that are displayed on Alpha Display keypads.

COMM. FAILURE	Indicates that a failure has occurred in
(or FC)	the telephone communication portion of
	your system. CALL FOR SERVICE.
SYSTEM LO BAT	Indicates that a low system battery
(or BAT with no	condition exists. Display is
zone No.)	accompanied by "beeping"* at the
	keypad. If this condition persists for
	more than one day (with AC present),
	CALL FOR SERVICE.
LO BAT	Indicates that there is a low battery
+ zone descriptor	condition in the wireless transmitter**
(or BAT with	number displayed (00 is RF keypad).
zone No.)	Accompanied by a single "beep"* (about
	once every 30 seconds) at the keypad.
	Either replace the battery yourself, or
	CALL FOR SERVICE. If the battery is
	not replaced within 30 days, a CHECK
	display may occur.
Rcvr Jam	Wireless part of the system is experiencing
(or CHECK 90)	RF interference which may impede
	reception from wireless sensors.**
ALARM 1xx	Indicates a communication problem
FAULT 1xx	between the control and a connected
CHECK 1xx	device (e.g., RF receiver, zone expander)
(or 91)	where the “xx” indicates the device
	address. CALL FOR SERVICE.
MODEM COMM	Indicates that the control is on-line with
(or CC)	the Central Monitoring Station's remote
	computer.
	The control will not report system
	activity while on-line. Wait a few minutes
	— the display should disappear.
BELL FAILURE	Indicates that the wiring connection to
(or CHECK 70)	the external sounder is at fault (open or
	shorted). Accompanied by “beeping” at
	the keypad. CALL FOR SERVICE.

– 40 –