Fisher & Paykel BGB48, BGB36 Clearances to Combustible Construction, General, Insulated Jacket

INSTALLATION

LOCATING GRILL/BUILT-IN CLEARANCES

Clearances to Combustible Construction**

min. 310 mm		grill
min. 310 mm	673 mm	exhaust
		min. 310 mm (to combustible

construction)

rotisserie

motor

616 mm
267 mm	Bottom of
	support flange	254 mm

centre of gas inlet

81 mm

51 mm	562 mm
	centre of gas inlet
	559 mm
	648 mm

FIG. 9

**DEFINITION OF COMBUSTIBLE MATERIAL - Any materials of a building structure or decorative structure made of wood, compressed paper, plant fibers, vinyl/plastic or other materials that are capable of transferring heat or being ignited and burned. Such material shall be considered combustible even though flame-proofed, fire-retar- dant treated or surface-painted, or plastered.

Important!

It is required that a minimum of 3 x 65 cm2 of ventilation opening be provided for both the left and right sides, as well as the back of enclosure (Fig. 10), in order to safely dissipate unburned gas vapours in the event of a gas supply leak.

WARNING!

Note specific built-in enclosure ventilation requirements. See text and Fig. 10.

GENERAL

The grill is designed for easy placement into built-in masonry enclosures. For non-combustible applications the grill drops into the opening shown in Fig. 10 and hangs from its side flanges. A deck is not required to support it from the bottom. When using the insulated jacket in a combustible enclosure application, see the bottom of Fig. 10. The insulation jacket assembly must be supported from the bottom by a ledge on each side and back or a solid deck.

Acarpenter’s “spirit level” should be used to assure that the unit is level both front-to-back and side-to-side. If it is not level, burner combustion may be erratic or the unit may not function efficiently for grease flow. If the floor is uneven or has a decided slope, re-leveling may be required after each moving of a freestanding unit.

INSULATED JACKET:

WARNING!

Installing this product into a combustible enclosure without an insulated jacket could result in fire, property damage and personal injury.

If the grill is to be placed into a combustible enclosure, an approved insulated jacket is necessary. Insulated jackets are available from your dealer. Use only the DCS by Fisher & Paykel insulated jacket which has specifically been designed and tested for this purpose. Review the detail drawing shown (Fig. 10) and take into account the provisions shown for gas line hook-up clearance in the right rear corner. It is required that ventilation holes are provided in the enclosure to eliminate the potential build-up of gas in the event of a gas leak. The supporting ledges or deck must be level and flat and strong enough to support the grill and insulated jacket. The counter should also be level.

11