Safety and warnings
3
This product should not be sealed into the bench with silicone or glue. Doing so will make future servicing difficult. Fisher & Paykel will not be liable for costs associated with releasing such a product, nor for repairing damage that may be incurred in doing this.
When this product is installed it shall not be used as a space heater, especially if installed in marine craft or caravans.
No combustible material or products should be placed on this product at any time.
Before you install the appliance, ensure that
the benchtop is square and level and no structural members interfere with space requirements. there is a minimum of 60 mm between the cutout and the rear or side wall.
if the cutout is less than 100 mm from the wall, some form of protection against heat is used, such as ceramic tiles.
if the appliance is a CT2802 model, the power supply cable is rated for use at 100OC.
a suitable disconnection switch is incorporated in the permanent wiring, mounted and positioned to comply with local wiring rules and regulations. A means of disconnection with at least a 3 mm air gap contact separation in all poles must be incorporated into the fixed wiring in accordance with the wiring rules, unless the local wiring rules allow for the following variation of these requirements: A means of disconnection from the supply having an air gap separation in all active (phase) conductors must be incorporated into the fixed wiring.
the interconnection cord between the cooktop and the oven or control box will not be accessible via cupboard doors after installation. This applies to any extension cord as well, even if they are
you consult local building authorities and
the appliance is rated 5.9 kW at
When you install the appliance, ensure that you comply with the following requirements: If prolonged use is anticipated, or the cooktop is mounted above a drawer space, a thermal protection barrier between is recommended AND
Where the base of this product is accessible after installation, a thermal protection barrier MUST be installed to prevent contact.
If a thermal protection barrier is installed below the cooktop, this barrier must be made of heat resistant material capable of withstanding sustained exposure to temperatures up to 70 oC, be at least 30 mm and no greater than 75 mm below the base of the cooktop and have FOUR ventilation holes or TWO similiar holes for CT2802 models (min 50 mm – max 70 mm diameter, see Fig. 1 for details). These ventilation holes must be open to free air.
We recommend that the thermal protection barrier be removable, so that the cooktop can be easily secured with the supplied clamps.
Use
