10
Selecting a programme and operating your machine
Changing the programme after the programme has started
You can use this feature after your machine has started to dry your clothes under higher or lower temperatures.
For example:
Press and hold the Start/Pause/Cancel button for about 3 seconds to cancel the programme in order to select Extra Dry programme instead of ready to iron programme.
Select the programme by rotating the programme knob. Press Start/Pause/Cancel button to start the programme.
The programme which is selected first will go on even if the programme selection button is moved and another programme mode is selected while the machine is operating. You must cancel the ongoing programme in order to change the drying programme. (See, ‘Ending the programme through cancelling’ page 11).
Adding/removing laundry in standby mode
If you want to add or remove laundry into/from your machine after the drying programme has started, put the machine into pause mode by pressing the Start/Pause/Cancel button. The drying process will stop. Open the door at pause position and close it again after adding or taking out laundry. Press Start/Pause/Cancel button to start the programme.
Any laundry added after the drying process was started may cause the already dried clothes in the machine to intermingle with wet clothes and the result will be wet laundry after the drying process is over.
It is not recommended to add laundry after the programme is started as it will increase the programme time and energy consumption.
Childproof lock
There is a childproof lock to prevent any programme interruption due to the pressing of keys while the programme is on. The loading door and all keys except the On/Off key on the panel are deactivated when the childproof lock is active.
In order to activate the childproof lock, press on the Start/Pause/Cancel and buttons simultaneously for 3 seconds.
| To start a new programme after the programme is over or to interrupt the |
| programme, the childproof lock should be deactivated. |
| To deactivate the childproof lock, press the same buttons for 3 seconds. |
Fig.6 Using the | Two beeps will sound when the childproof lock is activated. A single beep |
childproof lock | will sound when the lock is deactivated. |
|
