10
Care and cleaning
To replace the carbon filter
1Stop/reset the carbon filter alert signal.
If “C” is flashing in the display alternately with the fan speed setting, turn the VentSurface off by pressing the 
button, then press the 
and 
buttons simultaneously and hold down for five seconds until you hear a beep. “8” will show in the display until the alert signal has been
reset.
2Unplug the VentSurface from the power outlet or switch off at the wall.
3Unclick the front edge of the magnetic stainless steel cover plate and gently lower it down (Fig.2).
4Remove the aluminium mesh filter: pull gently on the release handle with one hand and support the filter from underneath with the other (to prevent it falling onto the cooking surface). This will reveal the back carbon filter.
5Release the carbon filter by turning the two slotted screw heads 90 degrees with one hand while supporting the carbon filter with the other.
6Fit the replacement carbon filter.
7 Replace the aluminium mesh filter.
8 Click the protective cover plate back into place.
9 Plug the VentSurface back into the power outlet or switch on at the wall.
