Fisher & Paykel HC90 manual Cleaning the stainless steel surfaces, Replacing the lamps

Care and cleaning

Cleaning the stainless steel surfaces

11

Do not use abrasive cleaners, cloths or pads to clean your VentSurface. Wipe the stainless steel surfaces often, using warm water and a mild household detergent. The stainless steel may also be cleaned with a suitable cleaner and polish.

Note: if you choose to use a commercial stainless steel cleaner, please read the label to make sure it does not contain chlorine compounds as these are corrosive and may damage the appearance of your VentSurface.

Replacing the lamps

Wall-mounted (HC90) models have two, and island (HI120) models have four lamps. If you should need to replace the lamps, make sure you are using the correct type of light bulb (G4 halogen bulbs 10W max. each). Note: bulb replacement is not covered by your warranty.

1Unplug the VentSurface from the power outlet or switch off at the wall.

2 Allow the light bulbs to cool down.

3 Locate the outer metal ring of the lamp cover. Pressing it with your fingers, rotate it clockwise firmly, making sure you do not touch the glass cover. The cover will fall out.

Important!

Do not use a screwdriver or any other sharp metal object to force the lamp cover out, as doing so may result in the glass chipping.

4Remove the faulty bulb(s) using a soft

cloth. Do not touch the bulb with your fingers.

5 Replace with the new bulb(s) using a soft cloth. Make sure the new bulb(s) comply with the specifications above.

6Refit the lamp cover. Place the lamp

cover into its hole, making sure it is flush
with the glass surface (1). Using your
fingers, start rotating the outer metal	2
ring anticlockwise (2). To lock the lamp
cover into place, the small gripping hooks
on the outer rim of the metal ring need
to slide under the black plastic shroud	1
housing the lamp (similarly to a bayonet
mount mechanism).

7Plug the VentSurface in or switch the power outlet on at the wall.

Fig.3 Refitting the lamp cover