2
Installation instructions
Unpacking
To ensure the best performance from your new washer please follow the instructions below.
Removing the packaging
1Remove the outer packaging.
2Tilt the machine backwards and walk it off the bottom packer one foot at a time.
3Remove the bottom packer from under the machine by pulling it out the front.
4Lift the lid and remove the bowl packer from the bowl.
5 | Remove the hoses and accessories. |
|
|
|
6 | Keep the bottom packer and bowl packer in case they |
|
|
|
|
|
| ||
| are required for future transit. | Fig.1 Tilt washer backwards to remove packer | ||
Important!
Please ensure that the bottom packer has been removed before operating your machine.
In your clothes washer you will find:
■■1 hose guide
■■2 inlet hoses
■■4 rubber foot inserts (if not already inserted into the feet of your washer)
■■1 user guide
Location
Your washer must be installed on a level surface, and not on any textured floor coverings (eg carpet, rugs) to ensure that the opening at the bottom of the machine is not obstructed.
Drain hose
1 Carefully pull the drain hose out from the back of |
the machine by pulling the exposed part of the |
hose upward and outward. |
2 To guide the drain hose over the tub or standpipe |
the hose guide MUST be fitted to the drain hose. |
To prevent syphoning: |
The drain hose should not extend more than |
20 mm from the end of the guide. |
The height of the standpipe or tub should be |
between 850 – 1200 mm. |
Pull hose through guide
Flex hose guide apart
Standpipe 850 – 2400 mm
(20 mm) 
maximum
The drain hose can be trimmed to length. |
3 Place the drain hose in the tub or standpipe. |
