KitchenAid W10526086A Installation Requirements, Tools and Parts, Tools needed, Parts supplied

In the State of Massachusetts, the following installation instructions apply:

■Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts.

■If using a ball valve, it shall be a T-handle type.

■A flexible gas connector, when used, must not exceed 3 feet.

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation instructions.

Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed and engaged.

Failure to follow these instructions can result in death or serious burns to children and adults.

Anti-Tip

Bracket

Range Foot

To verify the anti-tip bracket is installed and engaged:

•Slide range forward.

•Look for the anti-tip bracket securely attached to floor or wall.

•Slide range back so rear range foot is under anti-tip bracket.

•See installation instructions for details.

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

■	Tape measure	■	³⁄₈" nut driver
■	Phillips screwdriver	■	Marker or pencil
■	T20® Torx®† screwdriver	■	Pipe-joint compound
■ Flat-blade screwdriver			resistant to LP gas
		■ Noncorrosive leak-detection
■	¹⁄₈" flat-blade screwdriver
			solution
	Level
■		For LP/Natural Gas
■	Hand or electric drill	Conversions
■	Wrench or pliers	■	½" combination wrench
■	Pipe wrench	■ ⁹⁄₃₂" (7.0 mm) nut driver
■	¹⁵⁄₁₆" combination wrench	■	Masking tape

■¹⁄₈" drill bit

Parts supplied

Check that all parts are included.

■3 - 10-32 hex nuts (attached to terminal block)

■3 - Terminal lugs

■LP/Natural Gas Conversion Kit (located on back of range near lower side)

■Burner grates

■Burner caps

■Oven racks

■2 - #12 x 1⁵⁄₈" screws (for mounting anti-tip bracket)

■Anti-tip bracket (taped inside upper oven with literature package)

Anti-tip bracket must be securely mounted to the back wall or floor. Thickness of flooring may require longer screws to anchor bracket to subfloor. Longer screws are available from your local hardware store.

Parts needed

If using a power supply cord:

■A UL listed power supply cord kit marked for use with ranges. The cord should be rated at 250 volts minimum, 40 amps or 50 amps that is marked for use with nominal 1³⁄₈" (3.5 cm) diameter connection opening and must end in ring terminals or open-end spade terminals with upturned ends.

■A UL listed strain relief.

Check local codes and consult gas supplier. Check existing electrical supply and gas supply. See “Electrical Requirements” and “Gas Supply Requirements” sections.

It is recommended that all electrical connections be made by a licensed, qualified electrical installer.

†®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.

3