2.Unscrew the regulator cap and remove the plastic cover.
A
B
A. Plastic cover
B. Regulator cap
3.Flip the regulator pin over and replace the plastic cover.
B
A
C
A. Natural gas position
B. LP gas position
C. Plastic cover
4.Screw the regulator cap securely back into place. Do not overtighten.
To Convert Surface Burners
1.If the burner grates are installed, remove them.
2.Remove the burner caps.
3.Using a Phillips or T20® Torx®† screwdriver, remove the burner base.
A 
C
B 
D
A. Burner cap | C. Burner base screws |
B. Gas tube opening | D. Burner base |
†®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
4.Apply masking tape to the end of a ⁹⁄₃₂" (7.0 mm) nut driver to help hold the Natural gas orifice spud in the nut driver while changing it. Press nut driver down onto the Natural gas orifice spud and remove by turning it counterclockwise and lifting out. Set the Natural gas orifice spud aside.
A
A. Natural gas orifice spud
Use the following chart for correct LP gas orifice spud for each burner. Refer to the model/serial rating plate behind the control panel for proper sizing of LP gas orifice spuds for each burner location.
LP Gas Orifice Spud Chart
Burner Rating | Color | Number |
4,000 BTU | Blue | 64L |
7,000 BTU | Black | 81L |
9,100 BTU | Green | 97L |
14,000 BTU | Red | 114L |
|
|
|
5.Replace the Natural gas orifice spud with the correct LP gas orifice spud. See the “LP Gas Orifice Spud Chart.”
6.Replace burner base and hand tighten the screws.
7.Replace burner cap.
8.Repeat steps 1 through 7 for the remaining burners.
9.Place Natural gas orifice spuds in plastic parts bag for future use and keep with literature package.
10.Replace burner grates.
11.Complete installation. See “Make Gas Connection” and Electronic Ignition System” sections.
Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" to ½" long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
18
