KitchenAid W10526086A Moving the Range, For power supply cord-connected ranges

4.Apply masking tape to the end of a ⁹⁄₃₂" (7.0 mm) nut driver to help hold the LP gas orifice spud in the nut driver while changing it. Press nut driver down onto the LP gas orifice spud and remove by turning it counterclockwise and lifting out. Set the LP gas orifice spud aside.

A

A. LP gas orifice spud

Use the following chart for correct Natural gas orifice spud for each burner. Refer to the model/serial rating plate behind the control panel for proper sizing of Natural orifice spuds for each burner location.

Natural Gas Orifice Spud Chart

Burner Rating	Color	Number
5,000 BTU	Green	107N
7,300 BTU	Yellow	125N
9,200 BTU	Orange	142N
10,000 BTU	Transparent	149N
15,000 BTU	White	180N
16,000 BTU	Black	195N

5.Replace the LP gas orifice spud with correct Natural gas orifice spud. See the “Natural Gas Orifice Spud Chart.”

6.Replace burner base and hand tighten the screws.

7.Replace burner cap.

8.Repeat steps 1 through 7 for the remaining burners.

9.Place LP gas orifice spuds in plastic parts bag for future use and keep with literature package.

10.Replace burner grates.

11.Complete installation. See “Make Gas Connection” and Electronic Ignition System” sections.

Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" to ½" long. The outer cone is not as distinct as the inner cone. Natural gas flames do not have yellow tips.

IMPORTANT: You may have to adjust the low setting for each cooktop burner.

Moving the Range

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation instructions.

Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed and engaged.

Failure to follow these instructions can result in death or serious burns to children and adults.

When moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.

If removing the range is necessary for cleaning or maintenance:

For power supply cord-connected ranges:

1.Slide range forward.

2.Turn manual shutoff valve to the closed position.

3.Unplug the power supply cord.

4.Disconnect the gas supply tubing.

5.Complete cleaning or maintenance.

6.Reconnect the gas supply tubing.

7.Open the manual shutoff valve in the gas supply line.

8.Plug in power supply cord.

9.Slide range back so rear range foot is under anti-tip bracket.

10.Refer to the “Verify Anti-Tip Bracket Is Installed and Engaged” section to verify engagement.

11.Check that range is level.

20