CARE AND CLEANING
Removing and refitting the side racks (and catalytic panels if installed)
●
●
IMPORTANT!
Catalytic panels are not supplied with oven, but can be purchased optionally. Contact your Elba dealer or visit our local website listed at the end of this document.
Only some full ovens have a lamp in the left oven wall.
Fixing screw |
Fig.17 Side rack and catalytic panel in full oven cavity
Fixing screw hole |
Fig.18 Side rack in compact oven cavity
To remove a side rack and catalytic panel
1Models with
2Using a small coin or a
3Remove the side rack.
●Once you have removed a side rack, the catalytic panel behind it (if fitted) will also be released.
To refit a side rack and catalytic panel
1If the oven has catalytic panels, align a panel with the fixing screw holes and hold it in place, making sure that:
●the arrow on the panel is pointing up
●if one panel has a hole, it will be on the left oven wall (to fit around the lamp)
2Loosely screw in the back fixing screw.
3Position the side rack. In full ovens, make sure it is the right way up, as shown.
4 Loosely screw in the front fixing screw.
5 Check that both fixing screws are straight, then tighten them.
6 Models with
27