Installation instructions
IT IS THE CUSTOMERS RESPONSIBILITY:
It is the customers responsibility to ensure that the product is electrically connected by a qualified electrical installer in conformance with the National Electrical code, ANSI/NFPA 70 (latest edition) and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269.
Unpacking the oven | US |
|
IMPORTANT!
Do not use door handles or any part of the control panel for lifting the product. Before the product is lifted, the oven doors and racks are to be removed.
1Carefully lay the product on its back. Remove the external wrapping and the bottom polystyrene protector and pallet. Stand the product up and remove all other polystyrene packaging.
2Remove the oven doors.
IMPORTANT!
Do not lift the door out by the handle as this may cause damage to the product.
Do not disengage the hinge hooks when the door has been removed as they are differcult to
Door Hinge
Junction Box location for undercounter installation
Hook
Clip
Door
Junction Box location for wall installation
-Open the oven door fully.
-Lift the catches on both of the hinges over towards you onto the hooks of the hinge arm (see picture below).
-Raise the door slightly, holding on either side near the handle, making sure that the clips stay on the hooks.
-Lift the door out.
3Remove the wire shelves and oven trays by sliding them out. Use both hands to remove each item. Remove the cardboard packaging from the oven cavity.
7
