Fisher & Paykel OR24SDMBGX manual Cleaning and maintenance

5	cleaning and maintenance
	GENERAL RECOMANDATION
WARNING
	✓ Important: Before any operation of cleaning and maintenance disconnect the
	appliance from the electrical supply.
	✓ It is advisable to clean when the appliance is cold and especially for cleaning the
	enamelled parts.
	✓ Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the sur-
	faces.
	✓ Avoid using cleaning products with a chlorine or acidic base.
Electrical Shock Hazard
	The oven must always be cleaned after every use, using suitable products and keep-
Plug into a grounded 3-prong	ing in mind that its operation for 30 minutes on the highest temperature eliminates
	most grime reducing it to ashes.
outlet.
Do not remove ground prong.	ENAMELLED PARTS
Do not use an adapter.	✓ All the enamelled parts must be cleaned with a sponge and soapy water only or other
Failure to follow these instructions
	non-abrasive products.
can result in death, fire, or
	Dry preferably with a chamois leather.
￿electrical shock.
	PAINTED PARTS AND SILK-SCREEN PRINTED SURFACES

✓Clean using an appropriate product. Always dry thoroughly.

3-prong polarized ground-type outlet

ground

prong

IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abra- sion. You are advised to use a soft cloth and neutral soap.

STAINLESS STEEL ELEMENTS

✓Stainless steel parts must be rinsed with water and dried with a soft and clean cloth or with a chamois leather.

✓For difficult dirt, use a specific non-abrasive product available commercially or a little hot vinegar.

✓Note: regular use could cause discolouring around the burners, because of the high flame temperature.

INSIDE OF OVEN

✓This must be cleaned regularly.

✓With the oven warm, wipe the inside walls with a cloth soaked in very hot soapy water or another suitable product.

WARNING

VERY IMPORTANT

Before any operation of maintenance disconnect the appliance from the electrical mains supply.

Do not use steam jet cleaners because the humidity could infiltrate into the appliance making it dangerous.

BURNERS AND GRIDS

✓These parts can be removed and cleaned with appropriate products.

✓After cleaning, the burners and their flame distributors must be well dried and cor- rectly replaced.

✓It is very important to check that the burner flame distributor and the cap has been correctly positioned - failure to do so can cause serious problems.

✓Check that the probe next to each burner is always clean to ensure correct operation of the safety valves.

✓In appliances with electric ignition keep the electrode clean so that the sparks always strike.

✓Note: To avoid damage to the electric ignition do not use it when the burners are not in place.

REPLACING THE OVEN LIGHT

Before any maintenance is started involving electrical parts of the appliance, it must be disconnected from the power supply.

–Let the oven cavity and the broil burner cool down;

–Switch off the electrical supply;

–Remove the protective cover;

–Unscrew and replace the bulb with a new one suitable for high temperatures (300°C- 570°F) having the following specifications: 120V 60 Hz, 15W, E14;

–Refit the protective cover.

NOTE: Oven bulb replacement is not covered by your guarantee.

18