Fisher & Paykel OR60 installation instructions Installation instructions

Installation instructions 9

Fitting the anti-tilt bracket

(seven-function models)

Important!

To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the anti-tiit bracket.

To fit the anti-tilt bracket:

0

1 After you have located where the cooker +15 is to be positioned, mark on the wall the place where the two screws of the anti-tilt bracket have to be fitted. Please follow the indications given in Fig.6a.

2Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.

Dotted line showing the position

of the cooker when installed

= =

75

min 95 - max 110

(depending on feet height adjustment)

Fig. 6a Fitting the anti-tilt bracket

FOURGAS COOKTOPFUNCTIONMODELS

Important!

Before drilling the holes, check that you will not damage any pipes or electrical wires.

3Loosely attach the anti-tilt bracket with the two screws supplied.

4Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can engage in the slot on the cooker’s back, as shown in Fig.6a.

5Tighten the screws attaching the anti-tilt bracket.

6Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot on the cooker’s back.

7Access the bracket and fit the lock pin;

Remove the drawer (Fig. 6b).

Fit the lock pin through the bracket, as shown (Fig.6c).

Refit the drawer.

1	Anti-tilt bracket	2
	attached on the
	rear wall
	Cooker’s
	back	Lock pin
Lock pin
		correctly fitted

1

2

3

4

Fig. 6b Removing the drawer

Slot on the

cooker’s back Fig. 6c Fitting the lock pin through the bracket