46Care and cleaning
Burner parts and trivets
You can remove and clean these parts with hot soapy water or
After cleaning, check that the burners and their flame spreaders are dry before replacing correctly.
It is very important to check that the burner flame spreader and the cap have been correctly positioned. Failure to do so can cause serious problems.
Note: to avoid damage to the electronic ignition, do not try to light a burner without all burner parts in place.
Replacing the auxiliary and semi-rapid burners
Carefully replace the burner parts as per the following Figs. Check that:
The ignitor is always clean to ensure
The probe is always clean to ensure correct operation of the safety valves.
Note: both the ignitor and probe must be very carefully cleaned using a toothbrush and methylated spirits (see Fig. 46).
Cap
Flame
spreader
Flame failure probe
Ignitor