Fisher & Paykel OR60 installation instructions Sliding shelf supports

Care and cleaning 73

Sliding shelf supports

The telescopic sliding shelf supports make it safer and easier to insert and remove the oven shelves and trays. They stop when they are pulled out to the maximum position. Wipe the supports with a damp cloth and a mild detergent only. Do not wash them in the dishwasher, immerse them in soapy water, or use oven cleaner on them.

To remove the sliding shelf supports:

1Remove the side racks by unscrewing the fixing screws (Fig. 76).

2Lay down the sliding shelf support and side racks, with the sliding shelf support

underneath.

3Find the safety locks. These are the tabs that clip over the wire of the side rack (arrow 1 in

Fig. 79).

4Pull the safety locks away from the wire to release the wire (arrow 2 in Fig. 79).

To re-fit the sliding shelf support onto the side racks:

1Screw the side rack onto the oven wall.

2Fit the sliding shelf support onto the top wire of a rack and press (Fig. 80). You will hear a click as the safety locks clip over the wire.

Important!

When fitting the sliding shelf supports, make sure that you fit:

the slides to the top wire of a rack. They do not fit on the lower wire.

the slides so that they run out towards the oven door, as shown in Fig. 80. both sides of each pair of shelf slides.

both sides on the same level. Note: you cannot fit the sliding shelf supports to the top shelf position.

MODELS WITH CERAMICFOURFUNCTIONGLASS COOKTOPMODELS

1

2

1

Fig.79 Removing the sliding shelf supports Fig.80 Refitting the sliding shelf supports