Fisher & Paykel OR90, OR60 installation instructions Fitting the anti-tilt bracket

OR60 MODELS

8Installation instructions

Fitting the anti-tilt bracket

Important!

To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the anti-tilt bracket.

To fit the anti-tilt bracket:

1 After you have located where the cooker

is to be positioned, mark on the wall the	0
place where the two screws of the anti-tilt
	+ 15

bracket have to be fitted. Please follow the indications given in Fig. 3a.

2Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.

Important!

Before drilling the holes, check that you will not damage any pipes or electrical wires.

3Loosely attach the anti-tilt bracket with the two screws supplied.

4Move the cooker to the wall and adjust the height of the anti-tilt bracket so that it can engage in the slot on the cooker’s back, as shown in Fig.3a.

5Tighten the screws attaching the anti-tilt bracket.

6Push the cooker against the wall so that the anti-tilt bracket is fully inserted in the slot on the cooker’s back.

7Access the bracket and fit the lock pin:

Remove the drawer (Fig. 3b).

Fit the lock pin through the bracket, as shown (Fig.3c).

Refit the drawer.

600 mm	(Cavity
	width)

365	235
	min105 max120

Fig. 3a Fitting the anti-tilt bracket

	Fig. 3b Removing the drawer
1	Anti-tilt bracket
	attached on the
	rear wall
	Cooker’s
	back
Lock pin

Slot on the cooker’s back

2

Lock pin correctly fitted

Fig. 3c Fitting the lock pin through the bracket