Fitting the anti-tilt bracket
Important!
To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the
To fit the anti-tilt bracket:
1After you have located where the cooker is to be positioned, mark on the wall the place where the two screws of the
2Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not damage any pipes or electrical wires.
3Loosely attach the
4Move the cooker to the wall and adjust the height of the
5Tighten the screws attaching the
6Push the cooker against the wall so that the
7Access the bracket and fit the lock pin:
Open the pivoting panel (Fig. 20b). Fit the lock pin through the bracket, as shown (Fig.20c).
Close the pivoting panel.
Installation instructions 17
900 | mm | (Cavity width) |
|
0 | min 220 max 245 |
+ 25
Fig. 20a Fitting the anti-tilt bracket
| Pivoting |
| panel |
| Fig. 20b Opening the pivoting panel |
1 | |
attached on the | |
| rear wall |
| Cooker’s |
| back |
Lock pin |
|
Slot on the cooker’s back
2
OR90 MODELS
Lock pin correctly fitted