Fisher & Paykel installation instructions Installation, RF610A, RF540A, RF201A only

12

Installation instructions

4. Installation

Your Fisher & Paykel Active Smart™ refrigerator is fitted with front and rear rollers, designed for moving the product in the forwards and backwards direction.

Avoid moving the product in a sideways direction	Raise the front of
	the refrigerator
as this may damage the rollers or the floor covering/
	Lower the front
surface.	of the refrigerator
A Your refrigerator will arrive with the front feet	Fig.10 Refrigerator feet
wound up making moving the product into its final
location a simple task.

BRoll the refrigerator into its final position making

sure there is the correct air gap between the product and surrounding cabinetry. See minimum clearance in cabinetry dimensions table (refer to page 11).

(RF610A, RF540A, RF201A only)

CAdjust the front feet down until the refrigerator is leaning backward with the front approximately 10 mm higher than the back. This will ensure a good door closing action. (Refer to Fig.10).

DAligning your refrigerator with cabinetry.

Align the sides of the refrigerator with the cabinetry by
adjusting the hinge side front foot.
Adjust the handle side foot until it touches the floor and	Fig.11 Uneven door alignment
takes a small amount of weight.
Once the refrigerator is in place and aligned with
cupboards/alcove push gently on the front top and check if
the product is rocking or stable.

5.Levelling of refrigerator door (RF610A, RF540A, RF201A only)

For uneven surfaces, front feet can be used to align the 2

doors.

If left hand door is too low, then unscrew the left hand foot to lift up the cabinet until the two doors top edges are aligned.

If right hand door is higher, then process the same way with right hand foot.

Fig.12 Even door alignment