Installation instructions
13
6. What to do if your product is unstable
EGently push the refrigerator back until the rear rollers contact floor.
Measure the gap under the front foot, which has come off the floor.
Obtain some solid packing material (hardwood, plastic etc) which fits firmly into the gap under the foot.
Note: Do not use metallic materials that may corrode and stain or damage floor coverings.
FWind both front feet up and roll the product out of position.
Place the packing material in the location diagonally opposite the front roller that lifts off the floor.
Make sure the packing material stays in place when the product is pushed back into position.
Ideally, the packing material is large enough to rest against the back wall so as to prevent it moving when the cabinet is pushed into position.
Example only
This foot lifts off the floor when top front is gently pushed back
Fig 13.Unstable refrigerator
Packing material goes under rear roller diagonally opposite front foot that lifts
Wall behind refrigerator
If this foot lifts off the floor when pushing gently on the top front of the refrigerator
Fig.14 Stabilizing your refrigerator
GRoll the refrigerator back into position and adjust front feet as per step D. (Check alignment and door closing action are satisfactory).
Make small adjustments to front feet where necessary.
Check that the product is stable (all 4 feet are on the floor). If not return to step E and repeat steps F and G.
