Fisher & Paykel RF610A, RF201A, RF540A installation instructions Installation instructions

Models: RF540A RF201A RF610A

1 52
Download 52 pages 41.34 Kb
Page 9
Image 9
12Run the 6 mm (¼”) tubing to back of the fridge ensuring there is enough tubing to pull out the refrigerator for service.

Installation instructions

7

11Attach double sided foam to the back of the water filter head as shown in Diagram 5. Write the date to be replaced on the filter (date installed + 6 months). Remove double sided foam backing and attach filter to the desired position as located in step 10 (refer to previous page).

12Run the 6 mm (¼”) tubing to back of the fridge ensuring there is enough tubing to pull out the refrigerator for service.

13Connect tubing into the water (solenoid) valve located on the right hand side of the unit (compressor) compartment as shown in Diagram 7. Beware of hot pipes.

14Pull gently on tubing to ensure it is locked in as shown in Diagram 8.

15 The completed installation should look like Diagram 9 on page 8.

Diagram 5

 

 

Fig.7 Double sided

 

foam attachment

Diagram 7

Diagram 8

Fig.8 Waterline connection to refrigerator

Diagram 6

16Turn isolating tap on and check that all connections are dry and free of drips. If not, please alert the plumber.

17Coil water line tubing behind the fridge. Push your refrigerator into place being careful not to kink or squash the water line running into the water (solenoid) valve.

18Read pages 9 – 14 carefully, and then turn refrigerator on.

19The first time you require water out of the dispenser, there will be a delay while the water reservoir fills up. As this is happening, the Manual background symbol will flash. Once the reservoir is full, this symbol will stop flashing.

20Run a further 3 litres (3 qt) through the system, stopping intermittently to ensure the reservoir is flushed out. Failure to do this will result in excessive dripping from your dispenser.

21Press Manual background until the Ice menu is highlighted then press Manual background to turn on the ice maker. Press Manual backgroundManual backgroundManual background together to force a cycle. The ice tray will flip. Force another cycle. The ice tray will flip and spill the water into the ice bin. Empty water and replace bin.

22You are now ready to enjoy chilled water and ice dispensing from your Active Smart™ refrigerator. Please note that once installation is complete a few drips may appear out of the dispenser over the next few days as the remaining trapped air is cleared.

Page 9
Image 9
Fisher & Paykel RF610A, RF201A, RF540A installation instructions Installation instructions