Fisher CZ-3D manual Pinpointing, Pushbutton Pinpoint Mode

PINPOINTING

PUSHBUTTON PINPOINT MODE

Target location is quick and easy using the push-button Pinpoint mode. You do not have to keep the coil moving to get a response in this mode.

1.Once the presence of a target is indicated by the “beep-beep” of your CZ-3D, simply move the coil away from the target area, and with the coil lightly on the ground or very close to it, press and hold the PINPOINT button. It doesn’t matter which mode you’re searching in, Autotune or Target ID.

2.As you bring the coil back into the target area, still pressing the PINPOINT button, the audio volume and pitch will increase and the meter needle will swing to the right.

3.When the needle, pitch and volume are at their highest points, stop the coil and move it forward and backward a couple of times, again stopping over the strongest response.

4.Repeat one more time, side to side and then front to back, keeping the PINPOINT button pushed in and stopping over the spot where you get the maximum volume, pitch and meter reading. Your target should be directly below the center of your search coil. With a little practice, you’ll find that you don’t even need to look at the meter unless you want a depth reading.

NOTE: For quick and accurate pinpointing of strong signals from large or shallow targets, push and hold the pinpoint button with the coil very close to the approximate target area. This will “tune-out” most of your target so you will receive a response directly over it. You may also try reducing the sensitivity level and/ or raising the coil so you can barely hear the signal.

For very weak signals, make sure you press the PINPOINT button with the coil completely out of the target area. You may also try moving the coil closer to the ground or increasing the sensitivity and volume levels.

18