Fisher CZ-3D manual Setting Up

SETTING UP

Drop-in battery compartments	Adjustable
and cable connector at rear of	non-metallic
housing(not shown)	lower stem
Removable control	Center
	section
housing (belt loop on
underside of housing)
Foam hand grip

Padded arm rest

Upper

lock nut Lower lock nut

Seven foot search coil cable

Upper stem

8-inch Spider

search coil

Nylon wing nut

(replacable

Duro-Neoprene

bushings, not

shown)

Built-in detector stand Figure 1. FISHER CZ-3D

The CZ-3D comes to you just about ready to use. Take a look at the diagram above and familiarize yourself with the parts of the CZ-3D before proceeding.

1.Unpack your new CZ-3D carefully. Save the carton and inserts for future storage or shipment.

2.Take a look inside the locknut on the upper stem. Note the clear plastic locking pad on the left hand side and loosen the lock nut by rotating it fully counterclockwise.

3.Slip the lower stem into the center section.

4.Adjust the stem length (using the guide pin & stem lock nut) and the coil angle (using the nylon wing nut) so the search coil rests flat on the ground about 6 inches in front of, and slightly to the right of your right foot, (to the left of your left foot for left handers). Your arm should be straight and relaxed, with the grip held loosely.

REMEMBER: The longer the shaft, the more you will have to bend your elbow and the sooner your arm will get tired. The CZ-3D is balanced for comfortable searching in a tight semicircle around the front of the operator.

3