Fisher CZ-3D manual Condensed Operating Instructions, Factory Pre-Set “Turn-On-And-Go” Marks

CONDENSED OPERATING INSTRUCTIONS

FACTORY PRE-SET “TURN-ON-AND-GO” MARKS

Your CZ-3D is fairly simple to operate, especially when compared to other target ID machines. Even so, we strongly recommend that you read this entire manual. You’ll be able to tune your CZ-3D to your specific needs and conditions. A good understanding what to do and why will lead you to more finds.

If you can’t wait any longer, and you’re an experienced detector user, here’s some quick instructions to get you going:

1.Set all the controls to the red numbered “Turn-On-And-Go” marks:

GROUND = 5 DISC = 4

SENSITIVITY = 3 MODE = ENHANCE VOLUME = 5

This puts you in a “coins-only” mode and you’re ready to start searching. Keep in mind that the GROUND setting of 5 is probably not the optimum setting for the ground you’re searching and that’s why the sensitivity level is set low—to reduce false signals caused by ground mineralization.

2.If you’re using headphones, adjust the volume controls for a comfortable volume when the coil is passed over a large shallow object.

3. Walk slowly, overlap your sweeps and keep the search coil moving. Remember you are in a “motion” search mode and the coil must be moving at least slightly to detect a target.

4.When you get a good, repeatable signal, pinpoint the target by placing the coil on the ground away from the target, pushing and holding the pinpoint button and then bringing the coil back over the target.

5.Once you’ve pinpointed the target, note the approximate depth reading on the meter, then identify it by releasing the pinpoint button and moving the coil side to side in short strokes over the target. The meter needle will lock onto the appropriate target classification.

6.Happy Hunting!

2