APPENDIX
Problem: | Try these Solution | |
| Remote Control | ● Check the batteries. | |
| Units dose not | ● Make sure anything is blocking between the Remote Receiver and the Remote | |
Control Units. | ||
| work. | ||
● Make sure you are not too far from the projector when using the Remote Control | ||
| ||
| Units. Maximum operating range is 16.4 feet (5m). | |
|
| |
| Wireless Mouse | ● Check the cable connection between the projector and the computer. | |
| function does not | ● Check the mouse setting on your computer. | |
● Turn the projector before your turn on the computer. | ||
work. | ||
| ||
| The image data in | ● Check the memory card is inserted properly into PC CARD SLOT. | |
| memory card isn’t | ● Check SmartMedia or PC Card Adapter is set properly. | |
● Check MCI mode is selected. | ||
| displayed. | ||
● Check the image data is recorded in the memory card properly. | ||
| ||
| ● Start the projector again. | |
|
| |
| The image data | ● Check the projector is turned on. | |
| can’t be written in, | ● Check “Card access” in VIEW menu is selected. | |
● Check MCI Cable is connected properly. | ||
| read from the | ||
● Check the memory card is inserted properly into PC CARD SLOT. | ||
| memory card. | ||
● Check Media Card Imager (supplied) is installed in your computer properly. | ||
| ● Check the setting in Media Card Imager (like Serial Port Setting) is set properly. | |
|
|
High voltages are used to operate this projector. Do not attempt to open the cabinet.
Sanyo Service is easily obtained. If after following all operating instructions, you find that service is necessary, contact the SFS Corporation in Los Angeles, or the store where you purchased the unit. Give the model number and explain the difficulty. We will advise you how to obtain service.
45