Part Names and Functions

Rear Terminal / Side Terminal

 

q

 

 

 

 

 

 

 

 

 

 

 

 

✽

w

 

e

 

r

 

t

 

y

u

!0

!1

 

 

 

 

COMPUTER IN 2

RESET

USB

SERVICE PORT

COMPUTER IN 1

/ COMPONENT IN

 

 

 

DVI-I

MONITOR OUT

 

(VARIABLE)

R

AUDIO OUT

VIDEO IN

L

COMPUTER /

S-VIDEO IN

(MONO)

COMPONENT

AUDIO IN

 

 

 

USB

Rear Terminal

o i

Side Terminal

qUSB (Series B)

In order to operate the computer with the remote control and use the PAGE ed buttons on the remote control during a presentation, connect the USB port of the computer to the USB terminal with a USB cable. (p12, 18)

wSERVICE PORT

This jack is used to service the projector.

eCOMPUTER IN 1 / DVI-I

Connect computer output (Digital / Analog DVI-I type) to this terminal. (p18)

rCOMPUTER IN 2 /COMPONENT IN /

MONITOR OUT

This terminal is switchable and can be used for input from a computer, video equipment (Component or RGB Scart) or output to the other monitor. Optional cables are required when using this terminal as component input or RGB Scart 21- Pin Video input. (p69)

Set the terminal up as either Computer input or Monitor output properly. (Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1 / DVI-I terminal.) (p18, 20, 50)

tS-VIDEO IN

Connect the S-VIDEO output from video equipment to this jack. (p19)

yAUDIO IN

Connect the audio output from video equipment connected to t or o to this jack. (When the audio output is monaural, connect it to L (MONO) jack.) (p19)

uAUDIO OUT(VARIABLE)

Connect an external audio amplifier to this jack. (p18- 20)

This terminal outputs sound from AUDIO IN terminal (y or i).

iCOMPUTER/ COMPONENT AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to e or r to this jack. (p18, 20)

oVIDEO IN

Connect the composite video output from video equipment to VIDEO jack. (p19)

!0USB (Series A)

Connect supplied USB Wireless LAN Adapter or optionally supplied USB memory for Memory viewer operation. (Refer to the owner's manual supplied with optionally available USB memory.)

!1LAN connection

Connect the LAN cable. (Refer to the Owner's manual (Additional Vol.).)

✽RESET button

A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.

10