H
Battery Installation
Important Note: Use only a Power Wheels® Type H 6 volt battery with a Power Wheels® 25 amp fuse installed. Use of any other battery or fuse will damage your vehicle. Be sure to insert the battery correctly and always follow Power Wheels’ instructions for use and care. Make sure that you charge the battery for at least 18 hours before operating your vehicle for the first time. After first time use, charge the battery for at least 18 hours after each use. Never charge the battery longer than 30 hours. Failure to follow these instructions may damage your battery and will void your warranty.
1 | Seat |
|
• Lift the seat to access the battery compartment.
2 | Battery Retainer |
Battery Connector | |
| Rear of Vehicle |
| Battery |
•Place the battery upright in the battery compartment.
Make sure the battery connector extends towards the rear of the vehicle.
•Make sure a Power Wheels® 25 amp fuse in good condition is installed in the battery.
•Insert the ends of the battery retainer into the holes in the battery compartment.
3 |
#8 x 7/8" Screw – 1 |
Shown Actual Size |
•Lower the battery retainer over the top of the battery.
•Insert a #8 x 7/8" screw through the battery retainer and into the battery compartment.
•Tighten the screw with a Phillips screwdriver. Do not
4 | Motor Harness Connector |
| Battery Connector |
•Squeeze the tabs on each side of the motor harness connector.
•Plug the battery connector into the motor harness connector.
Please Note: If the battery connector will not plug into the motor harness connector, turn it over and try again! Do not force the battery connector into the motor harness connector.
16
