Assembly
Frame
Decorated
Side
Frame
Back
Legs
Seat Height
Adjusters
Position 4
Back Base Hole
Screw |
Retainers |
9 | Back Base Hole |
#10 x 7/8" Black Screw - 2 | Screw Retainer - 2 | |
SHOWN ACTUAL SIZE | ||
|
•Position a frame so that the decorated side is outward.
•Insert the back leg of a frame into the back base.
•Fit a screw retainer over the hole in the back base, as shown.
•Insert a #10 x 7/8" black screw through the screw retainer and back base.
•Tighten the screw with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other frame back leg to the other side of the back base.
Press
Lever
10
•While pressing the levers on the seat height adjusters, lift them to position 4 on the frame front legs, as shown.
Seat Assembly
Sockets | Sockets |
Seat Bottom
Tubes
11
•Fit the seat assembly between the two frames.
•Insert the seat bottom tubes into the sockets in each seat height adjuster.
Hints:
•Be sure the seat height adjusters are in the same position (position 4).
•You may need to push the frames apart slightly to fit the seat bottom tubes into the seat height adjuster sockets.
6
