Assembly
Seat Wire
“Snap” in Place
Seat Wire is
Through Hole in
Seat Wire Cap
Slots
17
•Lift the seat tubes slightly.
•With the seat wire hanging down, insert the ends of the seat wire through the slots in the seat, as shown.
Rounded Edge Up
Seat Wire
Cap Hole
Seat Wire
Cap
| Ends of |
| Seat Wire |
18 | Seat Wire |
Cap |
•While holding the seat wire in place, carefully turn the seat around so that the front of the seat faces you.
•Position the seat wire cap so that the rounded edge is upright.
•Fit each end of the seat wire through the hole in each seat wire cap.
Seat Wire
Caps
19
• Press to “snap” the seat wire caps into place.
Accessory Bin | Accessory Bin |
|
Grooves |
20 | Seat |
| |
| #8 x 11/4” Screw - 4 |
| Shown Actual Size |
• Turn the seat face down.
•Fit an accessory bin into the groove on each side of the seat, as shown.
•Insert two #8 x 11/4" screws through each accessory bin and into the seat. Tighten the screws with a Phillips screwdriver. Do not
8
