PREPARING AND USING THE REMOTE CONTROL UNIT

Changing the remote control code

The remote control unit will also work with other Sanyo cameras that can be operated by infrared remote control. When more than one camera is present, it is recommended to change the remote control code to ensure that only the intended camera operates when the remote control unit is used. The remote control code is set to “RC CODE 1” at the time of purchase.

<Changing the remote control code from “RC CODE 1” to “RC CODE 2”>

1 Aim the infrared emitter at the remote control sensor on the docking station.

2 Hold down the CH button and press the [I] button for about 3 seconds.

3 Press a button on the remote control unit and check that the camera is receiving correctly.

hThe remote control codes are retained even if the batteries in the

remote control unit and camera are replaced.

hIf the remote control codes for the remote control unit and the camera and do not match, the remote control unit cannot be used to operate the camera.

<Resetting the remote control code to “RC CODE 1”>

1 Aim the infrared emitter at the remote control sensor on the docking station.

2 Hold down the CH button and press the [J] button for about 3 seconds.

143English