Fluke 1526 Replacing the Fuse

MegOhmMeter

Maintaining the Meter

25

Replacing the Fuse

Warning

To avoid electric shock, personal injury or damage to the Meter, use ONLY

the specified fuse, and in accordance with the following procedure.

If the previous fuse test indicates that the fuse is defective (resista nce > 40 Ω), replace the

fuse as follows:

1. Turn the rotary switch to the OFF position.

2. Disconnect test leads from any power source.

3. Follow Steps 2 - 5 to remove the battery access lid as described under "Replacin g and

Disposing of the Batteries".

4. Unscrew the bottom cover as shown in Figure 6.

5. Remove the fuse as shown in Figure 6.

6. Replace with a new fuse.

7. Place the bottom cover on and secure the screws.

8. Insert the batteries. Observe the battery polarity shown in the batter y compartment.

9. Secure the battery access lid.

10. Test the fuse as described under "Test ing the Fuse".

Contents

Main Page i Table of Contents Title Page Page Page Fluke 1520 Unpacking the Meter Page Safety Information and Symbols Safety Information and Symbols YRisk of electric shock JEarth WSee manual IFuse T M P Conforms to EU directives t Page Safety Information and Symbols 6 Key functions Page Display Table 2 and Figure 2 describe the display. Page Using the Meter Connecting to the Circuit Under Test Page Page Page Page Using the LOCK Function to Measure Insulation Resistance Measuring Low Resistance Using the LOCK Function to Measure Resistance Measuring Resistance Measuring Voltage Checking the Battery Maintaining the Meter Cleaning Maintaining the Meter Replacing and Disposing of the Batteries Page Page Testing and Replacing the Fuse Testing the Fuse Maintaining the Meter Replacing the Fuse Page Replacement Parts and Optional Accessories Replacement Parts and Optional Accessories Principle of Measurement for Resistance I V R= (Ohms Law) Service Centers Specifications Page Page Page Page Limited Warranty & Limitation of Liability