®
2635A-PRINT 120
Serial 80 Column Dot-Matrix Printers
Instruction Sheet
Introduction
The
Installation
XWWarning
To avoid possible electric shock or personal injury:
•Verify that the line voltage marked on the back of the printer matches the local mains supply before connection.
Paper Separator |
Bail Arm |
Lever |
Paper |
Lever |
Power |
Switch |
Platen Knob |
egv001.eps |
Figure 1.
Shipping Contents
The Printer comes with the following items:
•Instructions for Printer setup and use (this sheet)
•Quick Start Guide
•Platen knob
•Ribbon cartridge
•Paper separator
•
•Check that the voltage listed on the rating plate, located on the back of the printer, matches the local mains supply voltage before applying power.
Some Printer parts have been removed for shipping. Reassemble its detached parts, as follows (see Figure 1 and the Quick Setup Guide for details):
1.Install the platen knob on the shaft on the right- side of the Printer, lining up the slot in the knob with the pin on the shaft.
2.Remove shipping tape from the Printer, and open the top cover.
3.The print head is held to one side by a plastic shipping retainer. Remove the retainer. Save the retainer in case the Printer ever needs to be shipped.
4.Center the print head by gently pushing it to the center of the platen area.
5.Attach the ribbon cartridge to the print head by setting the
6.Attach the paper separator by slipping the hooks on its front into the two slots on the top of the Printer.
•Fluke RS42 serial printer cable
PN 2558806 February 2006 ©2006 Fluke Corporation. All rights reserved. Printed in U.S.A. | 1 |